HPE Community read-only access December 15, 2018
This is a maintenance upgrade. You will be able to read articles and posts, but not post or reply.
Hours:
Dec 15, 4:00 am to 10:00 am UTC
Dec 14, 10:00 pm CST to Dec 15, 4:00 am CST
Dec 14, 8:00 pm PST to Dec 15, 2:00 am PST
Server Management - Systems Insight Manager
cancel
Showing results for 
Search instead for 
Did you mean: 

Version Control repository manager stop working

 
SOLVED
Go to solution
Gareth H Wilson
Frequent Advisor

Version Control repository manager stop working

Since going to 5.2 we have found that if we go to a servers SMHP and then into the version control agent page and start pushing drivers out from there after about 10 installs the VCRM then stops working on the hp sim server(the clients running the SMHP just say the VCRM cannot be contacted) and if i look on the SIM server the service is running fine and so far the only way to get it back running is to physically bounce the SIM server as doing a restart of the VCRM service doesnt fix it.

Anyone else seeing this ?

Cheers in advance
2 REPLIES
Ervinck Kevin
Valued Contributor
Solution

Re: Version Control repository manager stop working

This is a known issue.

Uninstall the SMH and VCA on your HP SIM server an roll them back to versions from Support Pack 7.91.
Gareth H Wilson
Frequent Advisor

Re: Version Control repository manager stop working

ok have done that will keep an aye on whether the VCRM stops allowing connections again