Server Management - Systems Insight Manager
cancel
Showing results for 
Search instead for 
Did you mean: 

WBEM and SSH Errors

MP2k
Occasional Contributor

WBEM and SSH Errors

I have insight manager installed but trying to discover the only host and getting errors below. ANy ideas? Does WBEM need to be install on target machine? Can this be done manually as trying through CMS does not work for WBEM & SSH.

 

 

 

WBEM protocol settings are not valid/enabled for this system in HP SIM. Check yo
ur HP SIM settings for identification via WBEM.
Subscribe to WBEM / WMI Indications ................................. [FAILED

 

 

Configure SSH for host-based authentication ......................... [FAILED]
Configuration failed to complete due to the following exception:
    Connection
to the target system failed due to Connection refused: connect.Target system mig
ht be down or does not have a SSH server. The network connection problem could a
lso cause this issue.

2 REPLIES
Steve Begley
Trusted Contributor

Re: WBEM and SSH Errors

Hi,

 

The WBEM agents need to be installed on the target system - what type of system is it?

 

WBEM was introduced to replace SNMP due to the lack of security on SNMP V1 and V2 -

this security issue was fixed in SNMP V3 which is both encrypted and authenticated.

 

If you want to use the WBEM protocol - you will need to specify the target credentials to

use on the CMS.

 

Hope this helps - regards,

 

Steve.B.

Tea break over - back on yer heads!
MP2k
Occasional Contributor

Re: WBEM and SSH Errors

in installed WBEM but keep getting this error

 

WBEM protocol settings are not valid/enabled for this system in HP SIM. Check yo
ur HP SIM settings for identification via WBEM.
Subscribe to WBEM / WMI Indications ................................. [FAILED] 

Send test WBEM/ WMI indication from the system ...................... [FAILED]
CMS has to be subscribed for WBEM / WMI indications before it can receive a test
indication.