WMI mapper proxy configuration

[Robert Luessi]

I want to use the WMI mapper to manage Windows hosts behind a firewall, but on a different Ports then the default that uses port 5989. Which configurations have to be changed on the CMS and on the Proxy System behind the firewall, that the WMI mapper still works?

[ramesh_naik_]

Hi Robert,

Not sure whether you are looking for the same thing that I am looking into!!!!!

Please check the page 430 and 431 in case you have not referred:
http://h10018.www1.hp.com:80/wwsolutions/misc/hpsim-helpfiles/hpsim_userGuide.pdf

Regards,
rmn

[Robert Luessi]

Thanks,
Did you ever configured a different Port on a WMI Mapper proxy?
Do I need to configure something on the WMI client side?
Documentation only says:
In the Port number field, enter a port number. The WMI Mapper Proxy uses this port number to communicate with the WMI client.

[ramesh_naik_]

Hi Robert,

Was just going through this document called "Managing HP servers through firewalls with HP SIM 5.0 " here:
http://h18013.www1.hp.com/products/servers/management/hpsim/infolibrary.html?jumpid=reg_R1002_USEN#b3

It gives information about WMI mapper through firewalls
See if this helps you.....

Regards,
rmn

[Robert Luessi]

Used default https port 5989. we had to open the firewall in and outbound onthis port.