HPE Community
Servers - General
1753659 Members
5908 Online
108798 Solutions
New Discussion

Adding a SATA HDD to ProLiant DL380 Gen9

 
daitan
Occasional Visitor

‎12-18-2018 08:04 AM

‎12-18-2018 08:04 AM

Adding a SATA HDD to ProLiant DL380 Gen9

Hi,

Is it possible to hotplug a SATA Hard Drive if I've already setup an array of SAS disks?
Will I be able to install ESXi in that separated Hard drive?

 

Thank you in advance!

0 Kudos
Reply
1 REPLY 1
Torsten.
Acclaimed Contributor

‎12-18-2018 08:16 AM - edited ‎12-18-2018 08:17 AM

‎12-18-2018 08:16 AM - edited ‎12-18-2018 08:17 AM

Re: Adding a SATA HDD to ProLiant DL380 Gen9

Depending on the array controller this should work, you just cannot mix SATA and SAS in the same array.

 

You may consider to install ESX on an internal SD card or USB too.


Hope this helps!
Regards
Torsten.

__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.
__________________________________________________
No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!   
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.