Servers - General

Re: HP PROLIANT ML30 HARD DRIVES NOT RECOGNIZED

 
Raphael_George
Occasional Contributor

HP PROLIANT ML30 HARD DRIVES NOT RECOGNIZED

Hello everyone. I'm trying to install a 4th HDD in my ML30 Gen 10 server. But so far I can only see three. I see a single power cable running from the powerpack with four plug-in points into the hard drives. And I plugged them all successfully including the Four SATA cables too. Yet only three hard drives are coming up
2 REPLIES 2
Ihaqueit
Valued Contributor

Re: HP PROLIANT ML30 HARD DRIVES NOT RECOGNIZED

Any raid configured?

I Haq
sudhirsingh
HPE Pro

Re: HP PROLIANT ML30 HARD DRIVES NOT RECOGNIZED

@Raphael_George

Power off the server and reset the SAS Cable and Hard Disk Drive power cable (cable SATA 4 In 1 kit)

If does not work, try to swap drive with other bay and isolate.

Regards,

Sudhir

While I am an HPE Employee, all of my comments (whether noted or not), are my own and are not any official representation of the company

>Accept or Kudo