HPE Community
Servers - General
1752350 Members
6136 Online
108787 Solutions
New Discussion юеВ

Re: HP PROLIANT ML30 HARD DRIVES NOT RECOGNIZED

 
Raphael_George
Occasional Contributor

тАО09-01-2021 01:47 AM - last edited on тАО09-07-2021 06:21 PM by

тАО09-01-2021 01:47 AM - last edited on тАО09-07-2021 06:21 PM by

HP PROLIANT ML30 HARD DRIVES NOT RECOGNIZED

Hello everyone. I'm trying to install a 4th HDD in my ML30 Gen 10 server. But so far I can only see three. I see a single power cable running from the powerpack with four plug-in points into the hard drives. And I plugged them all successfully including the Four SATA cables too. Yet only three hard drives are coming up
0 Kudos
Reply
2 REPLIES 2
Ihaqueit
Trusted Contributor

тАО09-01-2021 08:27 AM

тАО09-01-2021 08:27 AM

Re: HP PROLIANT ML30 HARD DRIVES NOT RECOGNIZED

Any raid configured?

I Haq
Reply
sudhirsingh
HPE Pro

тАО09-06-2021 05:29 PM

тАО09-06-2021 05:29 PM

Re: HP PROLIANT ML30 HARD DRIVES NOT RECOGNIZED

@Raphael_George

Power off the server and reset the SAS Cable and Hard Disk Drive power cable (cable SATA 4 In 1 kit)

If does not work, try to swap drive with other bay and isolate.

Regards,

Sudhir

While I am an HPE Employee, all of my comments (whether noted or not), are my own and are not any official representation of the company

>Accept or Kudo

0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.