Servers - General
cancel
Showing results for 
Search instead for 
Did you mean: 

Power protector web interface not starting?

 
kknight1
Occasional Contributor

Power protector web interface not starting?

I spun up  new VM running SUSE 12 and I ran the install for hp power protector, when its done. I am not getting an interface on the ip address with ports 4679 or 4680

I run systemctl list-units --all | grep UPS and I get

MGE UPS management on port 4680. but thats all. and still no web interface.

any assistance will be greatly appreaciated.

1 REPLY 1
Highlighted
ShruthiSK
HPE Pro

Re: Power protector web interface not starting?

Hi, 

1. What is the Model of the UPS being used?

2. Please confirm if the steps for Installation has been followed step-by-step as stated in the Power Protector user guide (Pg 27-31) : https://support.hpe.com/hpsc/doc/public/display?sp4ts.oid=5106151&docLocale=en_US&docId=emr_na-c02881291&withFrame

Regards,

Shruthi (HPE Employee)

----------------

Was this helpful? Like this post by selecting the Kudos option below!

Accept or Kudo