- Community Home
- >
- Servers and Operating Systems
- >
- HPE ProLiant
- >
- Servers - General
- >
- R5500 UPS management module intial config
Categories
Company
Local Language
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Discussions
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Community
Resources
Forums
Blogs
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
09-23-2009 10:45 AM - last edited on 03-15-2013 02:05 AM by Cathy_xu
09-23-2009 10:45 AM - last edited on 03-15-2013 02:05 AM by Cathy_xu
R5500 UPS management module intial config
I have four new R5500s each with a management module. I can't get connected to any of them using hyper terminal. I have followed the directions and double checked everything numerous times, but it just doesn't work.
I have tried from an XP laptop, a few different HP servers. I made sure that I have the connection set up with 115200-8-N-1-N, but I can't get any output to hyper terminal.
I have also tried various serial cable combinations. Any ideas?
P.S.This thread has been moved from ProLiant Servers - Netservers > to Servers > general-HP Forums Moderat
- Tags:
- UPS
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
10-06-2009 12:46 AM
10-06-2009 12:46 AM
Re: R5500 UPS management module intial config
Connect it to the host's serial port (or laptop serial port), open hyperterminal, select the settings you mention above, and then connect.
THEN go to the UPS module and press the reset button on the module - this should reboot the card, and you should see the card boot via hyperterminal. Interrupt the boot when you see the message "press any key within 5 seconds".
You'll then be dumped into a configuration menu, where you can set the IP.
Hope that helps.
-tjh