SAN Server Configuration

[Cyber-Code-Tech]

Hello every one

Please I need a help in my case:

I have two servers DL 380 G10  with no hard drives, both are connected through fibre (SFP) to a MSA 2050 SAN Server with 4 SSD each 1.9 TB, I have vSphere 7.0 installed on the servers,,,,,, I need to know how to configure the Server or the Hypervisor (vSphere) or the MSA 2050, so that I assign two SSDs to each server and how I can see the storage from the server (vSphere) to start deploying the vms.

Sorry if I make it long, but I `m new tothe servers and appreciate any help

[Suman_1978]

Hi,

I dont have a straight answer for this, but I have pasted some resources, hope it helps.

HPE MSA 1050/2050/2052 Best practices
https://psnow.ext.hpe.com/doc/a00015961enw

HPE MSA 2050 User Guide
https://support.hpe.com/hpesc/public/docDisplay?docId=a00017710en_us

HPE MSA 2050 SAN Storage - Supported Configurations
https://support.hpe.com/hpesc/public/docDisplay?docLocale=en_US&docId=emr_na-a00028199en_us

Thank You!
https://support.hpe.com/hpesc/public/home

[ArunKKR · Accepted solution]

Hi,

The configuration from MSA end is quite simple.

You could create a disk group in RAID 1 using 2 SSD hard drives under each Pool.

The next step would be to create a volume under each Pool and map to ESXI host servers.

You may refer to the SMU guide for information on creating a disk group, volume and volume mapping:

https://support.hpe.com/hpesc/public/docDisplay?docId=a00017707en_us

Please refer to the MSA vmware best practices guide as well:

https://psnow.ext.hpe.com/doc/4AA4-7060ENW

[Cyber-Code-Tech]

Thank you for the help.