Community
Servers - General

Spp cli wont open

 
SOLVED
Go to solution
Sepehryf
Frequent Visitor

‎11-18-2018 06:44 AM - edited ‎11-18-2018 07:18 AM

‎11-18-2018 06:44 AM - edited ‎11-18-2018 07:18 AM

Spp cli wont open

CLI wont open by hitting ctrl + alt +d + b + x
What is the problem
I tried in many servers and it works but in that server g8 it wont
0 Kudos
Reply
5 REPLIES 5
Torsten.
Acclaimed Contributor

‎11-18-2018 02:00 PM

‎11-18-2018 02:00 PM

Re: Spp cli wont open

Disabled since the first 2018 SPP for security reasons.

Enable it by flipping the ILO security DIP switch on the board to off.

Hope this helps!
Regards
Torsten.

__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.
__________________________________________________
No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!   
0 Kudos
Reply
Sepehryf
Frequent Visitor

‎11-18-2018 08:55 PM - edited ‎11-18-2018 08:57 PM

‎11-18-2018 08:55 PM - edited ‎11-18-2018 08:57 PM

Re: Spp cli wont open

hi tanx to you torsten

i know i must flip the iLO security DIP switch to off without doing that we cant flash the iLO and i've already done that but CLI still wont open for this server

0 Kudos
Reply
Torsten.
Acclaimed Contributor

‎11-18-2018 11:36 PM

‎11-18-2018 11:36 PM

Re: Spp cli wont open

What SPP you are using?


Hope this helps!
Regards
Torsten.

__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.
__________________________________________________
No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!   
0 Kudos
Reply
Sepehryf
Frequent Visitor

‎11-18-2018 11:40 PM

‎11-18-2018 11:40 PM

Re: Spp cli wont open

Spp version 2018.03.0
0 Kudos
Reply
Torsten.
Acclaimed Contributor

‎11-19-2018 04:02 AM

‎11-19-2018 04:02 AM

Solution

Re: Spp cli wont open

SPP2018.03 and later are supported for Gen9 and Gen10 servers only.


Hope this helps!
Regards
Torsten.

__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.
__________________________________________________
No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!   
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.