UPS Management Module Mac address

[Alex Hay]

Has anyone had any issues with the mac address on the UPS Management Module no displaying correctly. Also the serial number as "admin"

I tried to restore the setttings to factory defaults and it goes back to the same think.

Has anyone tried this:
1. In the HP UPS Management Module Service Menu, go to the Module
Configuration menu, and then select the r option to enter the Restore
Configuration to Manufacturer Settings submenu.
2. Select BootP or set a static IP address.
3. Enter the following, case-sensitive commands at the command prompt:
a. GOMAC—Restores the MAC address of the

[Brian Vo]

Alex,

-Those hidden commands should enter at the Module Configuration Menu. MAC address is entered with a space in between bytes.

-It seems your new module's FW could have been corrupted. Try to flash it with FW v2.0 again, download it from here:
"http://h18004.www1.hp.com/products/servers/proliantstorage/power-protection/software/module/ups/index.html"

Brian

[Gäumann]

the command GOMAC is not recognized. How do I have to do it?
How did you change serial number and Hardware version?

[Gäumann]

GOMAC is not recognized. Where can I find a documentation of these hidden commands.
I also have to change Hardwareversion (currently reading 0) and serial number

[Gäumann]

I found the solution here:

http://www.staff.stir.ac.uk/p.g.ward/af401afirmware.html

The command for the Serial number is GONU