- Community Home
- >
- Servers and Operating Systems
- >
- Servers - General
- >
- Re: Unable to assign IP to HP UPS R3000XR using se...
-
- Forums
-
- Advancing Life & Work
- Advantage EX
- Alliances
- Around the Storage Block
- HPE Ezmeral: Uncut
- OEM Solutions
- Servers & Systems: The Right Compute
- Tech Insights
- The Cloud Experience Everywhere
- HPE Blog, Austria, Germany & Switzerland
- Blog HPE, France
- HPE Blog, Italy
- HPE Blog, Japan
- HPE Blog, Middle East
- HPE Blog, Russia
- HPE Blog, Saudi Arabia
- HPE Blog, South Africa
- HPE Blog, UK & Ireland
-
Blogs
- Advancing Life & Work
- Advantage EX
- Alliances
- Around the Storage Block
- HPE Blog, Latin America
- HPE Blog, Middle East
- HPE Blog, Saudi Arabia
- HPE Blog, South Africa
- HPE Blog, UK & Ireland
- HPE Ezmeral: Uncut
- OEM Solutions
- Servers & Systems: The Right Compute
- Tech Insights
- The Cloud Experience Everywhere
-
Information
- Community
- Welcome
- Getting Started
- FAQ
- Ranking Overview
- Rules of Participation
- Tips and Tricks
- Resources
- Announcements
- Email us
- Feedback
- Information Libraries
- Integrated Systems
- Networking
- Servers
- Storage
- Other HPE Sites
- Support Center
- Aruba Airheads Community
- Enterprise.nxt
- HPE Dev Community
- Cloud28+ Community
- Marketplace
-
Forums
-
Blogs
-
Information
-
English
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content
04-26-2018 06:02 AM
04-26-2018 06:02 AM
Unable to assign IP to HP UPS R3000XR using serial port configuration cable
Hello,
I shutdown the UPS, installed the SNMP/Serial port card and powered up the UPS.
I have now connected the ethernet cable to the switch (the green light illuminated) and connected the configuration cable to the serial port on the computer.
I then installed HyperTerminal on my laptop and set the COM3 properties to 9600,8,1,N. Using the ASCII Setup I ticked the "echo typed characters locally".
However when I type:
IP
Then enter
No IP address is returned meaning I cannot assign the new IP.
I have checked the configuration cable (RS232) by creating a loop back connector and testing this using HyperTerminal and I get the letters I type doubling, i.e. IIPP.
Has anyone else had an issue assigning an IP address to their UPS and what they did to resolve this issue?
- Tags:
- UPS
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content
10-11-2018 02:00 AM
10-11-2018 02:00 AM
Re: Unable to assign IP to HP UPS R3000XR using serial port configuration cable
Have you tried the steps below:
https://www.manualslib.com/manual/888770/Hp-Ups-Network-Module.html?page=15
Hewlett Packard Enterprise International
- Communities
- HPE Blogs and Forum
© Copyright 2021 Hewlett Packard Enterprise Development LP