Servers - General
1748203 Members
3276 Online
108759 Solutions
New Discussion

Unable to disconnect virtual media applet in superdome2

 
Kauser
Advisor

Unable to disconnect virtual media applet in superdome2

Dear Concern,

Due to network fluctuation, virtual media is disconnected from host end in superdome2 but it is still showining connected. Hence we are unable to connect new virtual media with nPar1. Please assist us to disconnect virtual media applet with nPat1 and connect new virtual media with mentioned partition.

OA-UTDR-DB02-En01> show partition dvd all

Enclosure 1 DVD Drive: Present DVD Media: Present
Enclosure 2 DVD Drive: Present DVD Media: Absent

Partition DVD connection(s):
ParNum Partition Name Connected Enclosure
------ -------------- --------- ---------
1 nPartition01-VM - [Virtual Media Applet is in use.]================>Showing connected
2 nPartition-02 - In vPars mode, but no vPars defined
3:1 UDBCMS2 - No iLO available
3:2 UDBRTPS2 - Partition is not Active
4 test No 2

 

With Best Regards,

Kauser

1 REPLY 1
jsm6
HPE Pro

Re: Unable to disconnect virtual media applet in superdome2

Hi,

If not done earlier, pls try to "reset ILO" of nPar1' s monarch blade (lowest numbered blade) and check status.

OA cli > parstatus -p 1 -V    (find the lowest numbered or monarch blade and use below)

OA cli > reset ILO < blade number/bay>

Note : Though the reset is ONLINE and doesnt affect any operations, I would suggest you perform this during off-peak hrs.

Thanks and Regards.

I am a HPE Employee.
[Any personal opinions expressed are mine, and not official statements on behalf of Hewlett Packard Enterprise]

Accept or Kudo