- Community Home
- >
- Servers and Operating Systems
- >
- HPE ProLiant
- >
- ProLiant Servers - Netservers
- >
- microserver gen8 ilo error - embedded flash / sd c...
Categories
Company
Local Language
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Discussions
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Community
Resources
Forums
Blogs
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
11-19-2019 12:44 PM
11-19-2019 12:44 PM
microserver gen8 ilo error - embedded flash / sd card : embedded media initialization failed ...
Hi, I have an issue with ilo ...
logging into ILO results in the following error in ILO event log...
Embedded flash / sd card : embedded media initialization failed due to media write-verify test failure
Diagnosics - selftest reveals - Controller firmware revision 2.10.00 NAND read failure
Any advice anyone? Is there an inherent problem with this server, and I've been conned?
Thanks.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
11-20-2019 11:14 PM
11-20-2019 11:14 PM
Re: microserver gen8 ilo error - embedded flash / sd card : embedded media initialization failed ...
Hi ,
Please find the link mentioned below this is a reference advisory for the issue, please follow the steps mentioned in the resolution.
https://support.hpe.com/hpsc/doc/public/display?docId=emr_na-c04996097
Regards,
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
11-25-2019 01:09 PM
11-25-2019 01:09 PM
Re: microserver gen8 ilo error - embedded flash / sd card : embedded media initialization failed ...
Hi Ash,
Thanks for your reply. Sorry for not replying sooner.
Thanks for that link = I've tried the suggested solutions. my ilo was already 2.70.
After formattiing a couple of times, resetting / powering off ( and pulling cable out of the back for half hour),
The message I have now is ...
Controller firmware revision 2.10.00 NAND read failure: Media is in a WRITE-PROTECTED state
From googling around, it looks like the only solution is to replace the board. And that is not going to happen. I think I@ve been fleeced.
What's the NAND for anyway? Is it needed for anything specifically?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
12-10-2019 02:46 PM
12-10-2019 02:46 PM
Re: microserver gen8 ilo error - embedded flash / sd card : embedded media initialization failed ...
Hi,
Just a bump -
Hi Ash,
After formattiing a couple of times, resetting / powering off ( and pulling cable out of the back for half hour),
The message I have now is ...
Controller firmware revision 2.10.00 NAND read failure: Media is in a WRITE-PROTECTED state
From googling around, it looks like the only solution is to replace the board.
Can you let me know what is the NAND please? Is it needed for anything specifically?