Servers and Operating Systems
Have questions about servers and operating systems? Find information, share knowledge, and discuss solutions with these HPE Community blogs and forums.
1753512
Members
5066
Online
108795
Solutions
Latest Articles and Discussions
How to update the Compaq Insight Manager Agents for NetWare to su ...
Posted to: Server Management (Insight Manager 7)
10-26-2000 After the server has been upgraded to contain NWPA drivers, the following steps should be followed to enable monitoring storage via Compaq Insight Management Agents for NetWare. This description ...
0
Kudos
749
Views
0
Replies
Setting up Multiprocessor support after Win2K is installed
Posted to: ProLiant Servers (ML,DL,SL)
10-26-2000 Configure the server hardware to the correct the "APIC Mode" settings. You must start System Configuration and press 'CTRL a' at the first menu after selecting F10 during boot. This activates "Ad ...
0
Kudos
261
Views
1
Reply
Setting up Multiprocessor support after Win2K is installed
Posted to: ProLiant Servers (ML,DL,SL)
10-26-2000 Configure the server hardware to the correct the "APIC Mode" settings. You must start System Configuration and press 'CTRL a' at the first menu after selecting F10 during boot. This activates "Ad ...
0
Kudos
261
Views
3
Replies
Setting up Multiprocessor support after NT is installed
Posted to: ProLiant Servers (ML,DL,SL)
10-26-2000 Adding additional processors to a server after NT is installed. None of this will be necessary if the system already had two processors working correctly and you are only adding more after that.I ...
0
Kudos
261
Views
3
Replies
Setting up Multiprocessor support after NT is installed
Posted to: ProLiant Servers (ML,DL,SL)
10-26-2000 Configure the server hardware to the correct the "APIC Mode" settings. You must start System Configuration and press 'CTRL a' at the first menu after selecting F10 during boot. This activates "Ad ...
0
Kudos
2880
Views
0
Replies
Setting up Multiprocessor support after Win2K is installed
Posted to: ProLiant Servers (ML,DL,SL)
10-26-2000 Configure the server hardware to the correct the "APIC Mode" settings. You must start System Configuration and press 'CTRL a' at the first menu after selecting F10 during boot. This activates "Ad ...
0
Kudos
2455
Views
0
Replies