HPE Community read-only access December 15, 2018
This is a maintenance upgrade. You will be able to read articles and posts, but not post or reply.
Hours:
Dec 15, 4:00 am to 10:00 am UTC
Dec 14, 10:00 pm CST to Dec 15, 4:00 am CST
Dec 14, 8:00 pm PST to Dec 15, 2:00 am PST
cancel
Showing results for 
Search instead for 
Did you mean: 

Only one path visible to EVA

 
Nancy Kafer
Frequent Advisor

Only one path visible to EVA

I have a Windows 2003 Ent. server with 2 HBAs. I have installed MPIO on the server. I have connected each HBA to separate switches and have verified that each is zoned properly.

When I try to add the server as a host in Command View (EVA 6000) I only see one port available for this server. I have verified that the port is fine on the switch, rebooted the server, disabled/enabled the port, HBAnywhere can see both HBAs. Nothing has made the port appear in Command View.

What else can I try to get the second port visible to the EVA?

Thanks.
2 REPLIES
Uwe Zessin
Honored Contributor

Re: Only one path visible to EVA

A reboot or a scan at the adapter level is usually sufficient to register the adapter's WWN on the EVA. One of my favourite errors during zoning is to create the zone, but forget to add it to the configuration.
.
Nancy Kafer
Frequent Advisor

Re: Only one path visible to EVA

After some more troubleshooting I discovered that it was a flaky HBA. After I replaced the HBA I could see my second HBA.

Thanks.