- Community Home
- >
- Servers and Operating Systems
- >
- Operating Systems
- >
- Operating System - HP-UX
- >
- Serviceguard different subnet issue
Categories
Company
Local Language
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Discussions
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Community
Resources
Forums
Blogs
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
03-16-2015 10:14 PM
03-16-2015 10:14 PM
Hi ,
We have 2 node cluster running on 10.1.4.xx N/W , can we have packages to run in altogether different IP range ,
Say 1 node wil be having one network with 10.1.3.xx & the other with network 10.1.2.xx .
Is it possible to create package with these diff IP ranges , which must be virtual ?
What are the things that needs to be checked in here , both from OS & N/W end .
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
03-17-2015 07:55 AM
03-17-2015 07:55 AM
SolutionHi,
As per my knowledge you can setup service guard as long you have all nodes IPs in same subnets .
For setting up packages with different IP subnet than node can also be done.
Since you are going to use one single NIC with two IPs ( 1 permanent and 1 Package IP in diffenet subnet) you network switch port should configured as "Trunk Port" so it can allow multiple VLAN.
Also in OS level additional route need to be added to support to second IP address .
Sincere Regards,
Aneesh