Serviceguard
cancel
Showing results for 
Search instead for 
Did you mean: 

chcheckconf Failed to evaluate network ERROR

 
vgburguillosg
Occasional Contributor

chcheckconf Failed to evaluate network ERROR

Hello Mates!

 

I trying to reconfigure My SG Cluster but when check my configuration file showme the following error:

 


#:/etc/cmcluster> cmcheckconf -v -C cmclconfig -P carg_pkg/carg_pkg.conf
Begin cluster verification...
Checking cluster file: cmclconfig
Checking nodes ... Done
Checking existing configuration ... Done
Gathering storage information
Found 271 devices on node oravp1a
Found 271 devices on node oravp1b
Found 273 devices on node oravp2a
Found 271 devices on node oravp2b
Found 270 devices on node oravp5a
Found 269 devices on node oravp5b
Found 271 devices on node oravp6a
Found 301 devices on node oravp6b
Analysis of 2197 devices should take approximately 20 seconds
0%----10%----20%----30%----40%----50%----60%----70%----80%----90%----100%
Found 68 volume groups on node oravp1a
Found 68 volume groups on node oravp1b
Found 69 volume groups on node oravp2a
Found 68 volume groups on node oravp2b
Found 67 volume groups on node oravp5a
Found 66 volume groups on node oravp5b
Found 67 volume groups on node oravp6a
Found 82 volume groups on node oravp6b
Analysis of 555 volume groups should take approximately 1 seconds
0%----10%----20%----30%----40%----50%----60%----70%----80%----90%----100%
Gathering network information
Beginning network probing (this may take a while)
Completed network probing
Failed to evaluate network
cmcheckconf: Unable to reconcile configuration file cmclconfig
 with discovered configuration information.

 

ANY Comments?

 

Thanks

1 REPLY 1
Highlighted
Bill Hassell
Honored Contributor

Re: chcheckconf Failed to evaluate network ERROR

This is a very large cluster so there won't be a sinple answer. The cluster config file likely has errors so I would first compare this file to the same file on the other nodes. I am assuming that the cluster is still running so cmviewcl should give you a picture of what is currently working. Start by using linkloop and ping to verify all the new or changed LAN ports in the cluster config file.

 

And posting a copy of cmviewcl -v will be useful.



Bill Hassell, sysadmin