Serviceguard
cancel
Showing results for 
Search instead for 
Did you mean: 

rhel 6.3 and 11.20.10 , cmcheckconf, network probe fails with messages couldn't talk to itself

Peter Struhar
Occasional Contributor

rhel 6.3 and 11.20.10 , cmcheckconf, network probe fails with messages couldn't talk to itself

Hello,

 

I would like to ask if somebody did experience during building of sglx 11.20.10 cluster on Rhel 6.3 during cmcheckconf error messages like :

 

[root@node1 ~]# cmcheckconf -v -C cluster.conf

Begin cluster verification...

Checking cluster file: cluster.conf.

MAX_CONFIGURED_PACKAGES configured to 10.

Checking nodes ... Done

Checking existing configuration ... Done

MAX_CONFIGURED_PACKAGES configured to 10.

Gathering storage information

Found 1 devices on node node1

Found 1 devices on node node2

Analysis of 2 devices should take approximately 1 seconds

0%----10%----20%----30%----40%----50%----60%----70%----80%----90%----100%

Gathering network information

Beginning network probing (this may take a while)

Completed network probing

Network interface bond2 on node node1 couldn't talk to itself.

Network interface bond3 on node node1 couldn't talk to itself.

Network interface bond2 on node node2 couldn't talk to itself.

Network interface bond3 on node node2 couldn't talk to itself.

cmcheckconf: Unable to reconcile configuration file cluster.conf

 with discovered configuration information.

 

and what is the solution to fixing/workarounding the issue.

 

The interfaces have full connectivity and name resolution is setup according to guide.

 

thanks

1 REPLY
Chhaya_Z
Valued Contributor

Re: rhel 6.3 and 11.20.10 , cmcheckconf, network probe fails with messages couldn't talk to itself

Hi,

 

Are the nics on the same subnet?

 

 

Regards,
Chhaya

I am an HP employee.
Was this post useful? - You may click the KUDOS! star to say thank you.