HPE Community
HPE EVA Storage
1752810 Members
5930 Online
108789 Solutions
New Discussion юеВ

Re: EVA and Zoning problem

 
BrianDoyle
Trusted Contributor

тАО02-09-2011 05:05 AM

тАО02-09-2011 05:05 AM

EVA and Zoning problem

EVA6400 and HP 4/24 SAN switch

I've cabled 2 host ports of each controller to the switches and enabled the switch ports.
In Port Admin i see the EVA WWN but cannot see the WWN in Zone Admin to create an Alias.

I've hardzoned the ports to an alias and it works but this is not a solution.

Can anyone suggest anything to try?
thanks
0 Kudos
3 REPLIES 3
Torsten.
Acclaimed Contributor

тАО02-09-2011 05:22 AM

тАО02-09-2011 05:22 AM

Re: EVA and Zoning problem

I have never seen this before - maybe a switch related (firmware) problem?

Hope this helps!
Regards
Torsten.

__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.
__________________________________________________
No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!   
0 Kudos
BrianDoyle
Trusted Contributor

тАО02-09-2011 05:31 AM

тАО02-09-2011 05:31 AM

Re: EVA and Zoning problem

I restarted the EVA controllers (separately) and they just appeared!
thanks
0 Kudos
krusty
Honored Contributor

тАО02-09-2011 05:00 PM

тАО02-09-2011 05:00 PM

Re: EVA and Zoning problem

FYI - More correct way to state is you used "port based zoning", as WWN zoning is also "hard zoning" (meaning using the ASIC rather than the name server, i.e secure)

Glad you "self resolved" you issue.

Cheers,

Curt
"In Vino Veritas"
0 Kudos
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.