SSSU commands hang

[Gregory janke_1]

VMS V7.3-2 system.
$ mc sssu
sel man nnn.nnn.nnn.nnn user=ausername pass=apassword
sel cell SomCel

Question: Any command issued after sel cell will just hang until I exit out of the utility. Has anyone encountered this, and if so, what was the remedy.

thanks,
Greg

P.S. This thread has been moved to HP Storage System Scripting Utility (SSSU). - Hp Forum Moderator

[Uwe Zessin · Accepted solution]

Does "SELECT CELL" come back with a prompt?

What happens if you replace "SELECT CELL..." with the "SHOW CELL FULL" command?

What version of SSSU are you using and what version of CV-EVA is installed on the management server?

[Gregory janke_1]

sel cell comes back with the correct cell prompt.

If I issue the show cell full inplace of the sel cell, I do not receive the prompt back.

SSSU for HP StorageWorks Command View EVA 4.00 [v4.0.18]

I'll send the CV version in a bit.

thanks

[Gregory janke_1]

and the CV version on mngt appliance is 4.1.1

[Uwe Zessin]

In that case I would upgrade SSSU first:
http://h20000.www2.hp.com/bizsupport/TechSupport/SoftwareDescription.jsp?lang=en&cc=us&prodTypeId=12169&prodSeriesId=471497&prodNameId=1114414&swEnvOID=1094&swLang=13&mode=2&taskId=135&swItem=co-36332-1

[Cem Tugrul]

Hi Greg,

also it would be better to have a such kind
of document

Good Luck,

[Uwe Zessin]

I suggest a current revision of the manual:

http://h20000.www2.hp.com/bc/docs/support/SupportManual/c00500912/c00500912.pdf

[Cem Tugrul]

Hey Uwe,
thank's for the fresh link,i also updated
mine...
:-)