HPE Community read-only access December 15, 2018
This is a maintenance upgrade. You will be able to read articles and posts, but not post or reply.
Hours:
Dec 15, 4:00 am to 10:00 am UTC
Dec 14, 10:00 pm CST to Dec 15, 4:00 am CST
Dec 14, 8:00 pm PST to Dec 15, 2:00 am PST
Storage Software
cancel
Showing results for 
Search instead for 
Did you mean: 

Vdisk presentation using SSSU

 
Joseph W Faske
Occasional Visitor

Vdisk presentation using SSSU

In the event of an extended hardware outage, we use our development host system as the backup to our production system. Both systems are connected to our EVA3000 SAN.

To do this, we just have to swap the presentation of our vdisks in the EVA3000 between the two hosts. We'd like to use SSSU to script the switch, because with the number of vdisks we have, this can take over an hour using the GUI. Problem is, we haven't been able to figure out the commands that only do presentation in SSSU.

Any help would be greatly appreciated.
1 REPLY
Uwe Zessin
Honored Contributor

Re: Vdisk presentation using SSSU

It's the "ADD LUN" command.

I suggest you use SSSU to take a "CAPTURE CONFIGURATION" (you should do that ALWAYS after making a change to your EVA), extract the "ADD LUN" commands from the original server and then modify them to suit your needs.
.