StoreEasy Storage

DL100 320GB storage server drive configuration

 
Christian Kratz
Occasional Contributor

DL100 320GB storage server drive configuration

Hello,

since 3 days, my DL100 Storage server has the first drive in rebuild state. In the same time, the 3° disk is dead.
For the moment, i only get the primary system, witch was on a RAID 1 LUN, on disk 0 and 1.

How long does the rebuild need ?
Is there a way to speed up the rebuild?

And does anyone know the default configuration of the system ?

A the begining, there is :
- Raid 1 for system 1 on 2 disks
- Raid 1 for system 2 on 2 disks
- Raid 5 on ???? disks for data

Thank you for help
3 REPLIES 3
Jon Paul
Trusted Contributor

Re: DL100 320GB storage server drive configuration

Hi Christian,
This sounds like a DL100 G1. The 320Gb model had 4x80GB SATA disks and an Adaptec 2410 RAID controller.
The primary OS is a RAID 1 set on disks 0 and 1.
The Secondary OS is a RAID 1 set on disks 2 and 3.
The Data Drive is RAID 5 across all 4 disks.
A rebuild of one disk should not take more than ~12 hours. If the drive has not rebuilt in that time, either the rebuild priority is set to low (view this in the Adaptec Storage Manager) and the system is busy constantly or there is a problem with the rebuild (i.e. the disk reports bad then good then bad).
Hope your problems get resolved.
Jon Paul
Christian Kratz
Occasional Contributor

Re: DL100 320GB storage server drive configuration

Thanks for the answer.
I dont find any information of the rebuild priority in my HP storage manager (version 4)

and also, there is no option in the boot of the adaptec 2410 card to change the rebuild priority... HELP
peyrache
Respected Contributor

Re: DL100 320GB storage server drive configuration

in adaptec directory run aaccli.exe
this is gui from adaptec that can do the job
JYP