Failed add new cage for my StoreEasy 1850

[Elfegume]

Hi,

I have problem with add two new cages to my StoreEasy 1850.

I installed the last versión 2017.05.5(29 May 2017): https://support.hpe.com/hpsc/swd/public/detail?sp4ts.oid=1008615901&swItemId=MTX_5d6712930cbe49fc887c02a830&swEnvOid=4184#tab-history

My enviroment have one StoreEasy 1850 with one Cage1, all is ok, but now I buy two cages news (cage2 and cage3).

I try this:

The system run ok, but the number identify is wrong.

after add the Cage3:

I try this:

The system with three cages is ok, but I can`t use de Dual domain Fault Tolerance.

Please any idea.

Thanks!!

[srinathajoshi]

Hi,

Good day.

It looks 7 digit segment display not taking Enlcosure number correctly.

Get the HPS report capture and ADU report after adding second enclosure.

First check with single domain cabling and make sure all the enclosure detected on SSA.

https://support.hpe.com/hpsc/doc/public/display?docId=emr_na-c05252635

• P1 on the disk enclosure I/O module is treated as the SAS in port.

• P2 on the disk enclosure I/O module is treated as the SAS out port.

• In single-domain configurations, one cable path is created between the host, the primary disk enclosure, and additional cascaded disk enclosures.

• In dual-domain configurations, two cable paths are created between the host, the primary disk enclosure, and additional cascaded disk enclosures.

Single domain is cascaded cabling - https://support.hpe.com/hpsc/doc/public/display?docId=emr_na-c04220021

Page no 36 for the reference.

If further details needed, get the HPE support and log the case.

Thanks.

BR,

Srinatha Joshi