1702 error

[Ayman Altounji]

I get a 1702 error on post after I plug my 20/40 autoloader into my ML 370. This is a "cable error" or some description which I think indicates a SCSI termination error.

If I have an used SCSI id for the Autoloader and the supplied SCSI terminator attached to the Autoloader, why am I getting this termination error?

Thanks

[Ayman Altounji]

Please reference the ML370 SCSI Cabling Guide .....

Cable Guide

[rachelgomez_123]

Check IBM ServerProven to ensure all options are compatible with your system.

Refer to your system's Hardware Maintenance Manual for appropriate installation and removal instructions.

Run diagnostics to test the hardware. If a failure is indicated, use the error code extension to isolate the cause. Complete SCSI device error codes are 12 characters long. The first eight characters of the SCSI error code are for device information - not error information. The error information is in the next four characters (error extension bytes). Failure to use the entire error code may result in incorrect FRU parts replacement.

Regards,

Rachel Gomez