- Community Home
- >
- Storage
- >
- Data Protection and Retention
- >
- StoreEver Tape Storage
- >
- 5300 tape array and device open problems
StoreEver Tape Storage
1753815
Members
8053
Online
108805
Solutions
Forums
Categories
Company
Local Language
back
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Discussions
back
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Blogs
Information
Community
Resources
Community Language
Language
Forums
Blogs
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
07-01-2003 06:46 PM
07-01-2003 06:46 PM
5300 tape array and device open problems
just installed a "refurbed" 5300 tape array on a rp7400. when we plug in a DLT 8000 from a good working system we get: "on tape open: No such device or address". ioscan -fnC tape sees this device, and device files are there (from insf -e). we can even see a daisy-chained Ultrium 230 (external device) on the same SCSI chain. moved the DLT back to the working 5300 and it works fine again. any suggestions? my guess is a bad 5300
1 REPLY 1
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
07-08-2003 02:41 AM
07-08-2003 02:41 AM
Re: 5300 tape array and device open problems
tape array internal cabling can be finnicky.
There is not much that can be done, apart from replacing the backplan under warranty or the entire array. I assume you have tried different slots.
Be aware that there is a fair old run of cabling inside the arrays and you shouldn't daisy chain more than a couple of devices on the same bus within the array
Eagles may soar in the clouds but weasels don't get sucked into jet engines
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.
News and Events
Support
© Copyright 2024 Hewlett Packard Enterprise Development LP