HPE Community
StoreEver Tape Storage
1753835 Members
7366 Online
108806 Solutions
New Discussion

Adding a terminator causes DDS4 device to have a status of NO_HW

 
Adele Taylor
Occasional Contributor

‎11-30-2003 01:43 PM - last edited on ‎03-09-2014 10:45 PM by

‎11-30-2003 01:43 PM - last edited on ‎03-09-2014 10:45 PM by

Adding a terminator causes DDS4 device to have a status of NO_HW

When ever I add a terminator to my DDS4 drive, the device has a status of NO_HW.

On reboot my drive does not exist and I can not locate it via sam.

Any ideas - PLEASE.

OS - HP-UX 11.0
Model - N4000

 

P.S. This thread has been moved from Disk to Tape Libraries and Drives. -HP Forum Moderator

0 Kudos
Reply
2 REPLIES 2
Adele Taylor
Occasional Contributor

‎11-30-2003 02:49 PM

‎11-30-2003 02:49 PM

Re: Adding a terminator causes DDS4 device to have a status of NO_HW

I've solved my error - Well HP Support did.
0 Kudos
Reply
Alexander M. Ermes
Honored Contributor

‎12-01-2003 12:15 AM

‎12-01-2003 12:15 AM

Re: Adding a terminator causes DDS4 device to have a status of NO_HW

Hi there.
Could you pls let us know, what the solution is ?
It might help some other people in the same situation.
Thanks in advance.
Alexander M. Ermes
.. and all these memories are going to vanish like tears in the rain! final words from Rutger Hauer in "Blade Runner"
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.