HPE Community
StoreEver Tape Storage
1753602 Members
6253 Online
108797 Solutions
New Discussion

AlphaServo 4000 Dat DDS2 not responding ..

 
Johnrh
Occasional Contributor

‎11-20-2006 06:50 AM - last edited on ‎09-29-2014 01:41 AM by

‎11-20-2006 06:50 AM - last edited on ‎09-29-2014 01:41 AM by

AlphaServo 4000 Dat DDS2 not responding ..

My first qestion is .. is the DAT in the lower shelf hot plugable ... or can I disable power to plub the DDS2 DAT back in to the shelf and not disturb the SCSI bus. It has a RZ29B-VW board installed in the shelf as well. My original problem was that the DAT was not responding at all and we pulled it to get additional information off of it. It is a TLZ7L-VA DAT 4mm loader w/snapin storage works carrier.

 

 

P.S. This thread has been moevd from General to Tape Libraries and Drives. - Hp Forum Moderator

0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.