HPE Community
StoreEver Tape Storage
1752568 Members
5338 Online
108788 Solutions
New Discussion юеВ

Boot Error after adding DLT4000

 
Andrew Moore_3
Occasional Advisor

тАО06-22-2004 07:10 AM

тАО06-22-2004 07:10 AM

Boot Error after adding DLT4000

When botting I get the following message: "1777-Slot1 Drive Array - Proliant Storage Enclosure Problem Detected. SCSI Port 2: Interupt Signal Inoperative - Check SCSI Cables. This is occuring on a Smart Array 5302-128 with firmware version 2.92.
That shouldn├втВмтДвt be a problem
0 Kudos
Reply
3 REPLIES 3
Bharat Katkar
Honored Contributor

тАО06-22-2004 07:16 AM

тАО06-22-2004 07:16 AM

Re: Boot Error after adding DLT4000

Hi,
i guess this could be SCSI bus termination problem. Also check for SCSI cables and loose connections.
Regards,
You need to know a lot to actually know how little you know
0 Kudos
Reply
Allan_24
Regular Advisor

тАО06-23-2004 10:25 AM

тАО06-23-2004 10:25 AM

Re: Boot Error after adding DLT4000

Try to use dedicated SCSI controller for your tape box. Basically, array controllers are designed to work more on active disk devices.

Cheers!
"You should be working"
0 Kudos
Reply
Tim Schaffer
Occasional Advisor

тАО06-23-2004 12:08 PM

тАО06-23-2004 12:08 PM

Re: Boot Error after adding DLT4000

Thats correct, the 5300 series controller only supports internal hot plug tape drives. Unless the DLT4000 is connected to something else, that is your problem.
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.