C1504 need info about dip switches and led blink codes

[AndreH]

Hello, please excuse my poor english.

I need information about an old DDS1 Drive C1504-69201 .

I am searching for LED Diagnostic Codes and DIP Switch Settings.

Didnt find usefull stuff using pages like google.

Is anybody able to help me ?

Thank you

[Vincent Farrugia · Accepted solution]

Hello,

Please view the attached document Chapter 1 pages 13, 15 and 21.

HTH,
Vince

[Vincent Farrugia]

Sorry, it didn't work, let me try again:

[Vincent Farrugia]

The file cannot be attached, never works... it's just a simple 200k pdf file, nothing special!!!

Please reply with your email address so that I can sent it to you.

HTH,
Vince

[AndreH]

Please send it to:

andre.hotzler@partner.bmw.de

Thank you very much.

[Vincent Farrugia]

Hello,

I send it right now.

HTH,
Vince

[AndreH]

Thank you very much.

[Eugeny Brychkov]

Andre,
in addition try this one
http://h20000.www2.hp.com/bizsupport/TechSupport/SupportTaskIndex.jsp?locale=en_US&taskId=115&prodSeriesId=63917&prodTypeId=12169&supportTaskId=614
All DDS drives have same 8 dip switches at the bottom. For hpux installations all are on except switch 3 which is off.
SCSI address is set at the rear of the drive, and you should see short explanation there (on the sticker or extruded on the metallic cover). There are 3 jupers 4 / 2 / 1 to set SCSI id (by bits, in binary format), and jumper for power term. If you'll short this jumper then drive will supply power for active terminators connected to the bus
Eugeny

[AndreH]

Hello,

Is it possible to delete the posted emailadress above?

Best regards

Andre Hotzler