StoreEver Tape Storage
cancel
Showing results for 
Search instead for 
Did you mean: 

C1504 need info about dip switches and led blink codes

SOLVED
Go to solution
AndreH
Occasional Advisor

C1504 need info about dip switches and led blink codes

Hello, please excuse my poor english.

I need information about an old DDS1 Drive C1504-69201 .

I am searching for LED Diagnostic Codes and DIP Switch Settings.

Didnt find usefull stuff using pages like google.

Is anybody able to help me ?

Thank you
8 REPLIES
Vincent Farrugia
Honored Contributor
Solution

Re: C1504 need info about dip switches and led blink codes

Hello,

Please view the attached document Chapter 1 pages 13, 15 and 21.

HTH,
Vince
Tape Drives RULE!!!
Vincent Farrugia
Honored Contributor

Re: C1504 need info about dip switches and led blink codes

Sorry, it didn't work, let me try again:
Tape Drives RULE!!!
Vincent Farrugia
Honored Contributor

Re: C1504 need info about dip switches and led blink codes

The file cannot be attached, never works... it's just a simple 200k pdf file, nothing special!!!

Please reply with your email address so that I can sent it to you.

HTH,
Vince
Tape Drives RULE!!!
AndreH
Occasional Advisor

Re: C1504 need info about dip switches and led blink codes

Please send it to:

andre.hotzler@partner.bmw.de

Thank you very much.

Vincent Farrugia
Honored Contributor

Re: C1504 need info about dip switches and led blink codes

Hello,

I send it right now.

HTH,
Vince
Tape Drives RULE!!!
AndreH
Occasional Advisor

Re: C1504 need info about dip switches and led blink codes

Thank you very much.
Eugeny Brychkov
Honored Contributor

Re: C1504 need info about dip switches and led blink codes

Andre,
in addition try this one
http://h20000.www2.hp.com/bizsupport/TechSupport/SupportTaskIndex.jsp?locale=en_US&taskId=115&prodSeriesId=63917&prodTypeId=12169&supportTaskId=614
All DDS drives have same 8 dip switches at the bottom. For hpux installations all are on except switch 3 which is off.
SCSI address is set at the rear of the drive, and you should see short explanation there (on the sticker or extruded on the metallic cover). There are 3 jupers 4 / 2 / 1 to set SCSI id (by bits, in binary format), and jumper for power term. If you'll short this jumper then drive will supply power for active terminators connected to the bus
Eugeny
AndreH
Occasional Advisor

Re: C1504 need info about dip switches and led blink codes

Hello,

Is it possible to delete the posted emailadress above?

Best regards

Andre Hotzler