HPE Community
StoreEver Tape Storage
1752291 Members
5142 Online
108786 Solutions
New Discussion юеВ

Re: Cannot open device (Unit not ready.) after the Cell Server name has changed

 
Koeppel, Martin
New Member

тАО06-26-2009 05:55 AM

тАО06-26-2009 05:55 AM

Cannot open device (Unit not ready.) after the Cell Server name has changed

After changing the name of the Cell Server I cannot use the MSL 6060 any loger. The robotic is working fine, the tape is inserted in the drive, but the job (backup or format) ist not starting. After a while there comes "Cannot open device (Unit not ready.) and the job fails. My NetApp VTL emulating an MSL6060 is working fine.

Has somebody an idea?

Martin
0 Kudos
Reply
3 REPLIES 3
TTr
Honored Contributor

тАО06-26-2009 06:46 AM

тАО06-26-2009 06:46 AM

Re: Cannot open device (Unit not ready.) after the Cell Server name has changed

> After changing the name of the Cell Server...
There is formal process to change the name of the cell server. Did you follow it and did you change it in all areas?Specially the device and media configuration?
0 Kudos
Reply
Koeppel, Martin
New Member

тАО06-27-2009 07:22 AM

тАО06-27-2009 07:22 AM

Re: Cannot open device (Unit not ready.) after the Cell Server name has changed

Sure,
the Virtual Library is working fine. It is emulating a MSL6060. I only have problems withe physical library an drive.
0 Kudos
Reply
Eblyn Solis
Honored Contributor

тАО06-29-2009 07:45 AM

тАО06-29-2009 07:45 AM

Re: Cannot open device (Unit not ready.) after the Cell Server name has changed

Hi Martin,
If you have DP omniback ,maybe you need to config again the library under the new name or change the name of the server who control the library.

Regards

Please assign a kudo to this post, if you find it useful.
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.