StoreEver Tape Storage
cancel
Showing results for 
Search instead for 
Did you mean: 

Configure MSL5026 on SAN EVA

 
Highlighted
CA1239446
Advisor

Configure MSL5026 on SAN EVA

Hello,

Today, my MSL5026G2 is SCSI attached with proliant server. I'd like to plug this library on the san network. What is the first step (after physical plug of course) ?

Thanks
4 REPLIES 4
Highlighted
meloni
Honored Contributor

Re: Configure MSL5026 on SAN EVA

First you need to add a router ( NSR E1200 ) that will route your scsi devices in SAN.
Then configure the router, creating a Map and assign the map to the host that should see and manage the robot and the Tapes.
---------------X-------------------X--------------------X----------------X--------------
If everything is under control, you are going too slow (Mario Andretti)
Highlighted
CA1239446
Advisor

Re: Configure MSL5026 on SAN EVA

The router is the fiber card ?
Highlighted
meloni
Honored Contributor

Re: Configure MSL5026 on SAN EVA

The NSR is a module that allow to route the parallel scsi signal to the FC scsi signal

this module is to be put in the library to allow the MSL to be seen in the SAN, connecting the NSR to the switch

http://h20000.www2.hp.com/bizsupport/TechSupport/Home.jsp?〈=en&cc=us&prodTypeId=12169&prodSeriesId=316024&cc=us〈=en

(and obvioulsy you cannot connect the parallel scsi cable from the drives to the EVA itself)
---------------X-------------------X--------------------X----------------X--------------
If everything is under control, you are going too slow (Mario Andretti)
Highlighted
CA1239446
Advisor

Re: Configure MSL5026 on SAN EVA

ok i'v got it and it's always plug into library.