StoreEver Tape Storage
1747984 Members
4732 Online
108756 Solutions
New Discussion

Re: Configuring HP StorageWorks Tape Autoloader LOT-2 with Ultrium 448

 
Waseem-HP
Advisor

Configuring HP StorageWorks Tape Autoloader LOT-2 with Ultrium 448

We are going to Backup Critical Data on Tapes.  

 

I just found in my Data Center Rack "HP StorageWorks

Tape Autoloader with

Ultrium 448 Tape Drive".

 

Its Powered on and not connected to anywhere.

 

I saw at the back there are two Ports SCSI Paralell as shown in the picture.

 

Thare is no support from HP as it is LTO-2.

 

How can i connect this to any server? if there is no SCSI port on other device than what port should be used?

 

 

P.S. This thread has been moved from Tape Backup (Small and Medium Business) to Tape Libraries and Drives. - Hp Forum Moderator

 

 

1 REPLY 1
Torsten.
Acclaimed Contributor

Re: Configuring HP StorageWorks Tape Autoloader LOT-2 with Ultrium 448

There is a drive only on the picture, not an autoloader.

 

However, you need a scsi hba and any kind of backup software that can handle the drive/loader.


Hope this helps!
Regards
Torsten.

__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.

__________________________________________________
No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!