- Community Home
- >
- Storage
- >
- Data Protection and Retention
- >
- StoreEver Tape Storage
- >
- DAT 40I
Categories
Company
Local Language
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Forums
Discussions
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Community
Resources
Forums
Blogs
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
тАО10-27-2002 04:33 PM - last edited on тАО12-17-2012 10:32 PM by Maiko-I
тАО10-27-2002 04:33 PM - last edited on тАО12-17-2012 10:32 PM by Maiko-I
DAT 40I
I have an nt 4.0 server with a dat 40i. The driver says it is not started. Although it seems to work with the HP software. I cannot get it to work with vertas exec. I think it is because the driver is not started. I have uninstalled and reinstalled to no use. It may be somthing simple I am missing, but I cannot figure it out. Any help would be appreciated.
P.S. This thread has been moved from Disk, Disk Arrays (Legacy) to Tape Libraries and Drives - HP Forums Moderator
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
тАО10-30-2002 01:26 PM
тАО10-30-2002 01:26 PM
Re: DAT 40I
- try to operate drive from NT backup utility. If it will work I guess veritas backup should be checked;
- install HP Library and Tape Tools ( http://www.hp.com/cposupport/information_storage/support_doc/lpg50128.html ) and see what it will tell you about this drive. Run tests, analyze device, upgrade its firmware;
- I feel driver may not be started because it is not needed - dat40i device was not discovered by your system - check SCSI controller, cables, termination, SCSI Ids (no conflicts, remove other devices off the bus to check)
Eugeny
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
тАО10-31-2002 04:05 AM
тАО10-31-2002 04:05 AM
Re: DAT 40I
Tim
- Tags:
- LTT