Email Subscription Notifications Suspended Temporarily
We are in the process of making navigation in the Servers and Operating Systems forums simpler and more direct. While doing this, we have to temporarily suspend email notifications for subscriptions. If you are subscribed to one or more discussion boards or blogs in the community, please check them daily to see new content. Notifications will be turned back on in a few days. We apologize for any inconvenience this may cause. Thanks, Warren_Admin
cancel
Showing results for 
Search instead for 
Did you mean: 

DAT24 LED

Wolfgang Wiedemann
Occasional Visitor

DAT24 LED

A Win2K advanced server, using a DAT24 (C1555B) drive. Upgraded firmware to latest version. Made a backup using Win2K native backup. Backup completed without errors.
Next time system powered up, BOTH the Tape and Clean LEDs came on steady.
LEDs still stay on with no interface connected and ONLY a power supply plugged in.
H - E - L - P ! ! !
2 REPLIES
Robert_Jewell
Honored Contributor

Re: DAT24 LED

Whenever the Drive and Clean LEDs come on at the same time there is a fault. If this never clears then the drive is probably bad and needs replacing.

-Bob
----------------
Was this helpful? Like this post by giving me a thumbs up below!
Vincent Farrugia
Honored Contributor

Re: DAT24 LED

Hello,

The Clean LED is steady amber isn't it?

The combination below:

Tape LED: Any
Clean LED: Steady Amber

signifies "Error Condition".

Replace the drive.

HTH,
Vince
Tape Drives RULE!!!