Email Subscription Notifications Suspended Temporarily
We are in the process of making navigation in the Servers and Operating Systems forums simpler and more direct. While doing this, we have to temporarily suspend email notifications for subscriptions. If you are subscribed to one or more discussion boards or blogs in the community, please check them daily to see new content. Notifications will be turned back on in a few days. We apologize for any inconvenience this may cause. Thanks, Warren_Admin
StoreEver Tape Storage
cancel
Showing results for 
Search instead for 
Did you mean: 

DAT40 & DLTVS80 on Alpha Server ES47

ibrahima_1
Occasional Contributor

DAT40 & DLTVS80 on Alpha Server ES47

I have one DAT40 and one DLTVS80 installed in the same channel on a rackmount.
I use a scsi cable PN 313375-002 to connect them to the ES47.

But when a restart the system, all the devices become unknown including the system disk.

If I run the command dsfmgr -K, all device drivers are rebuild but for the DAT40 and the DLTVS80.

Even if I run hwmgr-scan scsi followed by dsfmgr -K, the DAT40 and the DLTVS80 are not rekognized. Do I need to change the scsi cable? or what other reason may be the cause?
Thanks.
1 REPLY
Marino Meloni_1
Honored Contributor

Re: DAT40 & DLTVS80 on Alpha Server ES47

I do not known ALFA servers, but as a general rule,
-the tapes drive need a separate scsi controller VS the HDD.
-Also each device should have a unique SCSI ID, so check if every device on the scsi chain have a diferent ID.
-A scsi chain need to be terminated, check if you have a valid scsi terminator

if everythink looks ok, try to connect one device at a time, and see if just one work fine