cancel
Showing results for 
Search instead for 
Did you mean: 

FC MSL6000 LTO3

Nic Hooper
Occasional Contributor

FC MSL6000 LTO3

We have recenetly purchased a new FC 2 drive LTO 3 MSL6000 Library. When we went to set it up, I keep getting "Windows NT SCSI errors" in Arcserve 11.5, and Arcserve just keeps saying updating and intialzing. I have attached to straight to SCSI and it works fine, just when I connect it via FC, I get these errors. Its using a e1200-320 FC card connected to a 2/8-EL Storage works SAN switch. We have another SDLT library connected that works fine.
2 REPLIES
Nic Hooper
Occasional Contributor

Re: FC MSL6000 LTO3

I can see the Library and drive in Windows 2003 Device manager.
Marino Meloni_1
Honored Contributor

Re: FC MSL6000 LTO3

I have seen this before, try to put the terminator on the drive can instead of on the controller on the daisy chained scsi bus

marino