- Community Home
- >
- Storage
- >
- Data Protection and Retention
- >
- StoreEver Tape Storage
- >
- HP 9322 Library
Categories
Company
Local Language
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Discussions
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Community
Resources
Forums
Blogs
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
01-02-2014 11:26 PM - last edited on 01-05-2014 06:59 PM by Lisa198503
01-02-2014 11:26 PM - last edited on 01-05-2014 06:59 PM by Lisa198503
HP 9322 Library
Having a major issues
Error
4
85
20
Horiz: axis not found
Encoder did not showed being moving at time of intialization.
Replaced encoder on both motors, replace mother board, replace all boards.
Y axis and X axis boards, Still gives the same error.
There is a flag on the bottom but do not know if its just that.
When i run the command to calibrate give error that Axis did not find home.
Nothing is blockling the way of either axis, runs smooth. no obstruction or anything.
checked all belts and still nothing even change the red motor its has.
I dont know what to do anymore.
thanks for any helps
P.S. This thread has been moved from Storage Area Networks (SAN) (Enterprise) to Tape Libraries and Drives. -HP Forum Moderator