HP-UX 10.20 & IBM LTO library (3584)

[Rafael Noas_1]

Hi gurus!

What do you think? Will this work?

Thanks in advance.

[Leif Halvarsson_2 · Accepted solution]

Hi
I don't know which in application you are planning to use this library, there can be restsictions in the application too.
There is drivers for IBM LTO devices and HP-UX 10.20 at:
http://www.storage.ibm.com/hardsoft/tape/lto/oem/support/lto_ftp.htm

[Rafael Noas_1]

Thanks Leif!

That's exactly what I was looking for... :-) and I hope that will work...

Thanks.
Rafael

[Rafael Noas_1]

*&%&^$&^%#^%$...
this drivers has no support for LTO products on hp-ux 10.20...
*&^*&^%^$#%$

thanks anyway.

[Leif Halvarsson_2]

Hi
Sorry for this. As the page was called "IBM Ultrium tape device drivers" and there was an entry fot HP-UX 10.20 I assumed it contained a tape driver, I did not opened the README file.
Somewhere in this forum I have seen a notice about it was possible to use the IBM Ultrium drive with the stape driver. I can't find this thread, it seems to be something wrong with the search engine, I get no hts when searching for "atdd,ultrium,LTO,IBM" or whatever I search for. The stape driver is normally used with HP Ultrium drives and as this is supported for HP-UX 10.20 it can be a chance.

[Jeffrey Li]

ATDD supports IBM LTO tape devices on 64-bit HP-UX 11.00 and 11i PCI Bus systems (L, N and V-class servers) only.

The documents are located on: ftp://ftp.software.ibm.com/storage/devdrvr/Doc/IBM_ultrium_tape_IUG.pdf

The drivers are on:
ftp://ftp.software.ibm.com/storage/devdrvr/HPUX/