Email Subscription Notifications Suspended Temporarily
We are in the process of making navigation in the Servers and Operating Systems forums simpler and more direct. While doing this, we have to temporarily suspend email notifications for subscriptions. If you are subscribed to one or more discussion boards or blogs in the community, please check them daily to see new content. Notifications will be turned back on in a few days. We apologize for any inconvenience this may cause. Thanks, Warren_Admin
StoreEver Tape Storage
cancel
Showing results for 
Search instead for 
Did you mean: 

Is DAT 24e a LVD SCSI device?

Is DAT 24e a LVD SCSI device?

Hello.

I've got several problems to perform any backup with my HP SureStore DAT24 (external, SCSI) connected to my X4000 PC.

Reading X4000 specifications, it's got a 68-pin connector for external LVD SCSI devices.

Reading DAT24e specifications, it's got a Ultra 2 SCSI connector.

Are DAT24e and X4000 compatibles? Is DAT24e a LVD SCSI device?

Thank you very muc.

 

 

P.S. This thread has been moved from General to Tape Libraries and Drives. - Hp Forum Moderator

3 REPLIES
David Ruska
Honored Contributor

Re: Is DAT 24e a LVD SCSI device?

> Is DAT24e a LVD SCSI device?

A DAT24e is a single-ended, fast narrow device. (A DAT40 is LVDS).

In theory you can hook a single-ended device to an LVDS bus, with a SE or autosensing terminator. You will also have to convert from 68pins to 50pins.

Note however, the recommended HBA is a single-ended card.

Here's the install manual:
http://h200002.www2.hp.com/bc/docs/support/SupportManual/lpg28876/lpg28876.pdf
The journey IS the reward.

Re: Is DAT 24e a LVD SCSI device?

Thank you very much for your answer.

I've got a lot of problems to communicate X4000 with DAT24e through SCSI.

So, the solutions you suggest are:
+) Placing an autosensing terminator on DAT24e, or
+) Connecting the DAT24e to a Single Ended card, or
+) Connecting X4000 to a DAT40e

Am I right?

Regards.
David Ruska
Honored Contributor

Re: Is DAT 24e a LVD SCSI device?

> So, the solutions you suggest are:
> +) Placing an autosensing terminator on DAT24e, or
> +) Connecting the DAT24e to a Single Ended card, or
> +) Connecting X4000 to a DAT40e

From easiest to hardest:

1) Use a narrow SE card. If it has an HD connector, you will need an HD50 to LD50 cable. Use an LD50 SE active terminator.

2) If you have an unused external 68pin LVD adapter, then get a 68pin HD to 50pn LD cable. Again, use an LD50 SE active terminator.

The LVD card will switch to SE mode automatically.

The auto-sensing terminators are typically only 68pin HD.

If the card has a BIOS, you should see the device ID when you boot.

The journey IS the reward.