- Community Home
- >
- Storage
- >
- Data Protection and Retention
- >
- StoreEver Tape Storage
- >
- LT&T: first scan with Ultrium 920 SCSI completes w...
StoreEver Tape Storage
1752679
Members
5536
Online
108789
Solutions
Forums
Categories
Company
Local Language
back
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Discussions
back
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Blogs
Information
Community
Resources
Community Language
Language
Forums
Blogs
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
12-30-2008 02:36 AM
12-30-2008 02:36 AM
LT&T: first scan with Ultrium 920 SCSI completes with errors
I am encountering the following problem with a newly installed ultrium 920 scsi-drive: when starting LT&T, the initial hardware scan results in a "scan completed with errors". The drive is however found and there is no visible clue what kind of error really has occurred.
Previously the LT&T Installation Check run without any problem.
Here some configuration details:
Device: HP StorageWorks Ultrium 920 (1) SCSI Tape Drive in 1U Rack-mount Kit
Controller: HP SC11Xe Host Bus Adapter
Previously the LT&T Installation Check run without any problem.
Here some configuration details:
Device: HP StorageWorks Ultrium 920 (1) SCSI Tape Drive in 1U Rack-mount Kit
Controller: HP SC11Xe Host Bus Adapter
1 REPLY 1
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
01-05-2009 06:28 AM
01-05-2009 06:28 AM
Re: LT&T: first scan with Ultrium 920 SCSI completes with errors
This is normal if you are able to see the tape drive with a blue color then it was detected properly if not make sure backup services are stopped as well as removable storage.
Pablo Alvarado Siles
Pablo Alvarado Siles
One drink away from sleeping on the pavement
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.
News and Events
Support
© Copyright 2024 Hewlett Packard Enterprise Development LP