StoreEver Tape Storage
cancel
Showing results for 
Search instead for 
Did you mean: 

MSL 5000 series - mslutil.exe

Kate_10
Occasional Contributor

MSL 5000 series - mslutil.exe

I have been trying to connect to my msl using the provided serial cable and the MSL5000 utility provided for HP by Overland.

After attempting the connetion, I get a message "Verifying connection at 9600 baud". Then every time I get the message "Cannot connect to target."

I noticed that someone else had mentioned in a post that they had a similar issue. Is this a common issue or am I doing something obvious wrong?

Thanks,

Kate
1 REPLY
Kurt Beyers.
Honored Contributor

Re: MSL 5000 series - mslutil.exe

Kate,

Are you using the correct serial cable. The serial cable to connect to the NSR router (FC library) and the serial cable to the library are different.

I had the same problem when I was using the serial cable from the NSR to connect to the library. Untill I switched from serial cable (internal cabling is different).

If it still fails, you can use HP L&TT to upgrade the firmware as well.

best regards,
Kurt