MSL 6000

[Tommy_8]

I'm trying to connect a MSL6000 to an RP4440 via a brocade all connected with 2 gig fibre.
I've logged on to the MSL and set the fibre to LOOP, Autosense (hard AL_PA), Autodetect on
when I reboot the MSL and the server I can't see the MSL or the internal scsi drives, I've also configured the drivers in the kernel.
Can anyone help.

Regards Tony.

[Marino Meloni_1 · Accepted solution]

If you are connecting via Switch you should use N_port login
----------
Channel Port ConfigurationBy default, the configuration of the Fibre Channel ports is set to N_Port, forcing the router to negotiate a fabric only mode.
----------
forcing the connection to loop with hard AL_PA adress is only used with point to point connection or with Hubs

marino

[Tommy_8]

Thanks for the reply I'll try this and let you know.

Regards Tony