StoreEver Tape Storage
cancel
Showing results for 
Search instead for 
Did you mean: 

MSL2024 Second Drive Zoning

SOLVED
Go to solution
SAM-IT
Occasional Visitor

MSL2024 Second Drive Zoning

Hello everybody,

 

I want to add a second LTO-5 drive in a MSL2024, which I want to use with HP Data-Protector to make backups simultaneously, but I'm not be sure how to configure the "zoning" on the FC-Switch.

 

Should I configure a new zone with only the backupserver and the second drive, or should I only add the second drive to the zone with the backupserver and the first drive???

 

thx.

 

 

P.S. This thread has been moved from Storage Area Networks (SAN) (Enterprise) to Tape Libraries and Drives. -HP Forum Moderator

2 REPLIES
Mark Smithers
Regular Advisor

Re: MSL2024 Second Drive Zoning

Hello,

 

If you need the definitive word, then you should always reference the HP SAN Design Guide - latest version lurks here :

 

http://h20565.www2.hp.com/portal/site/hpsc/template.PAGE/public/psi/manualsResults/?sp4ts.oid=406734&spf_p.tpst=psiContentResults&spf_p.prp_psiContentResults=wsrp-navigationalState%3Daction%253Dmanualslist%257Ccontentid%253DGeneral-Reference%257Clang%253Den&javax.portlet.begCacheTok=com.vignette.cachetoken&javax.portlet.endCacheTok=com.vignette.cachetoken

 

As a rule of thumb though, you won't go that far wrong with "Single Initiator, Single Target" for every zone you create.  In short, create a new zone and put the new drive and backup server into that zone.

 

Kind Regards

Mark

 

SAM-IT
Occasional Visitor
Solution

Re: MSL2024 Second Drive Zoning

Hello Mark,

 

thx for the answer , but I tested several different configuration and it looks like that you had to place a second drive in the same zone with the first drive (MSL 2024) and the backupserver, otherwise you can't find the drive in the devicemanager of the server and the "HP Library and Tape Tools" also report any errors.

 

After correct zoning, the next problem I had was, that I had to change the SCSI-ID's of the drives in the "deviceconfig" of Data Protector by hand, because DP changed all ID's in a wrong way, but I dont't know why.

 

But know all seems to be good, and I can run my backup jobs simultaneously :)