HPE Community
StoreEver Tape Storage
1752794 Members
6665 Online
108789 Solutions
New Discussion

MSL6060

 
1926
Occasional Visitor

‎12-08-2011 10:44 AM

‎12-08-2011 10:44 AM

MSL6060

I am having a problem losing connectivity to the autochanger.  After I eject the tapes then go to insert new ones, DP says "no devices" . I ran ioscan and see this:

 autoch    2  0/2/1/0.8.0.255.0.2.0  schgr    NO_HW       DEVICE       HP      MSL6000 Series

I have tried a soft reset of the library, of the NS E1200-320 bridge card and nothing fixes the problem.  If I turn the library off and then back on it goes back to normal.

 

Any ideas?

0 Kudos
Reply
2 REPLIES 2
Torsten.
Acclaimed Contributor

‎12-08-2011 11:31 AM

‎12-08-2011 11:31 AM

Re: MSL6060

What firmware version is on the NSR? I have seen similar problems with older firmware.

Should be version 5.9.63.

Hope this helps!
Regards
Torsten.

__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.
__________________________________________________
No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!   
0 Kudos
Reply
Pramod M
Regular Advisor

‎01-09-2012 01:28 AM

‎01-09-2012 01:28 AM

Re: MSL6060

Hi,

 

Is it resolved? How?

 

I was having this type of issue while the Library management network port is connected. We resolved this temporarily by removing the gateway.

 

Please tell how you resolved this..

 

Regards,

 

Pramod

0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.