HPE Community
StoreEver Tape Storage
1751888 Members
5269 Online
108783 Solutions
New Discussion

MSl 4048 b4 40

 
mohamed_32
New Member

‎12-28-2009 10:55 AM

‎12-28-2009 10:55 AM

MSl 4048 b4 40

randomly i am getting error trasp error b4 40
i have msl 4048 with lto 3 single drive
0 Kudos
Reply
1 REPLY 1
Curtis Ballard
Honored Contributor

‎01-06-2010 09:34 AM

‎01-06-2010 09:34 AM

Re: MSl 4048 b4 40

B4 40 means that the cartridge present sensor didn't transition as expected on a pick or a place. Usually it means that the tape stuck in the slot a bit and when the robot tried to pick (pull) the tape out it didn't come out right away. If it's recovered you can ignore it but I recommend removing the magazines and manually pull/place each tape several times.

We have found some non-HP tapes that aren't shaped quite right and stick a bit but a few pull/place cycles smooths out the sharp edge.
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.