- Community Home
- >
- Storage
- >
- Data Protection and Retention
- >
- StoreEver Tape Storage
- >
- NSR imapping question
StoreEver Tape Storage
1752440
Members
5857
Online
108788
Solutions
Forums
Categories
Company
Local Language
back
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Discussions
back
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Blogs
Information
Community
Resources
Community Language
Language
Forums
Blogs
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
01-26-2005 10:25 AM
01-26-2005 10:25 AM
NSR imapping question
Hello
When you look at a NSR index table will the NSR itself show up on the table.
I can see all my servers in the index table but not the NSR?
I am trying to connect the NSR to a Cell Manger, the Cell Manager does not see any tape devices. I have disable zoning on the switch.
Thanks,
Gene
When you look at a NSR index table will the NSR itself show up on the table.
I can see all my servers in the index table but not the NSR?
I am trying to connect the NSR to a Cell Manger, the Cell Manager does not see any tape devices. I have disable zoning on the switch.
Thanks,
Gene
1 REPLY 1
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
01-26-2005 06:52 PM
01-26-2005 06:52 PM
Re: NSR imapping question
Not sure which table you are talking about. There is a table that registers all connected hosts (servers) and what mapping table is assigned to them. The NSR will not show up here, but I have seen FC switches - just ignore them.
The mapping tables define which hardware device is visible on which fibre channel LUN number. You usually map the library robot to LUN:0 and then the tape drives. The NSR (listed as protocol AF, if I remember correctly - sorry, I'm doing this from memory) is not required and can even be confusing to some operating systems.
The mapping tables define which hardware device is visible on which fibre channel LUN number. You usually map the library robot to LUN:0 and then the tape drives. The NSR (listed as protocol AF, if I remember correctly - sorry, I'm doing this from memory) is not required and can even be confusing to some operating systems.
.
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.
News and Events
Support
© Copyright 2024 Hewlett Packard Enterprise Development LP