TL891 Fault Code 2072

[CA1187186]

I am getting a Fault Code 2072 on a TL891 Minilibrary. I believe one of the tape drives is defective. I disonnected the power and data cables to the drive. Hence my error. How do I reconfigure the library so it only sees and uses one tape drive? I see jumpers on the board , but don't know if they will help.

[CA998057]

Isn't the front panel menu for this? I don't have a manual around and don't have a TL891 at this site, but I thought the config menus would allow you to enable/disable a drive.

rick

[CA1187186]

Well yes, but it does not let you configure the device for one or two tape drives. I found a way to boot the device while holding down a couple of buttons to reset the device. It then ran a diag. of the device and removed the second drive. It is working now. Thanks for the reply.

[Kenneth Byrne]

Hi Edward,

What are the front-panel buttons to go into this mode?

Thanks,
Ken

[G Meuwissen]

Hi Edward
Reconfiguration is achieved by pressing the Escape button on the frontpannel when powering up the TL891. When you have 2 drives installed it should read TL892 in the display. After reconfiguration with 1 drive it reads TL891.

Success