HPE Community
StoreEver Tape Storage
1752810 Members
5839 Online
108789 Solutions
New Discussion

Ultrium 3000 on Red Hat ES 5.5 64 Bit with P212 HBA

 
Michael Malizia
New Member

‎08-26-2010 06:39 AM

‎08-26-2010 06:39 AM

Ultrium 3000 on Red Hat ES 5.5 64 Bit with P212 HBA

I am trying to install an Ultrium 3000 on a P212 HBA controller that is installed in a ML350 G6. The controller and tape drive show during boot but Red Hat ES 5.5 does not show the tape drive in the /proc/scsi/scsi file.

I have already loaded the latest firmware updates and the latest cciss driver.

Any ideas on what to try next?
0 Kudos
Reply
1 REPLY 1
Torsten.
Acclaimed Contributor

‎08-26-2010 07:02 AM

‎08-26-2010 07:02 AM

Re: Ultrium 3000 on Red Hat ES 5.5 64 Bit with P212 HBA

Look if your tape is in the supported list:

http://h18000.www1.hp.com/products/quickspecs/13203_na/13203_na.html




Refer to this page:

http://www.hp.com/products1/storage/compatibility/tapebackup/ISS/Detail/16-0068-0192.html



Consider to use HP LTT to check!

Hope this helps!
Regards
Torsten.

__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.
__________________________________________________
No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!   
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.